The speed configuration is supported for 1 Gigabit Ethernet copper SFPs and not supported for 1 Gigabit
Ethernet optical SFPs.
Note
Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to configure the Fast Ethernet interface to transmit at one gigabit:
RP/0/RSP0/CPU0:router(config)# interface FastEthernet 0/0/2/0
RP/0/RSP0/CPU0:router(config-if)# speed 1000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
127
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
speed (Fast Ethernet)
To Next Page
Loading...
Need help?
General
