log efd
To enable logging of Ethernet Fault Detection (EFD) state changes to an interface (such as when an interface
is shut down or brought up via EFD), use the log efd command in CFM domain service configuration mode.
To disable EFD logging, use the no form of this command.
log efd
no log efd
Syntax Description
This command has no keywords or arguments.
Command Default
EFD logging is disabled.
Command Modes
CFM domain service configuration (config-cfm-dmn-svc)
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When EFD logging is enabled, a syslog is generated whenever the EFD state of an interface changes.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to enable EFD logging:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet cfm
RP/0/RSP0/CPU0:router(config-cfm)# domain D1 level 1
RP/0/RSP0/CPU0:router(config-cfm-dmn)# service S1 down-meps
RP/0/RSP0/CPU0:router(config-cfm-dmn-svc)# log efd
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
272
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
log efd
To Next Page
Loading...
Need help?
General
