aps group (global)
To add an automatic protection switching (APS) group and enter APS group configuration mode, use the aps
group command in global configuration mode. To remove a group, use the no form of this command.
aps group number
no aps group number
Syntax Description
Number of the group. Range is from 1 to 255.
number
Command Default
No APS groups are defined.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
An APS group contains one protect (P) SONET port and one working (W) SONET port. The working and
protect ports can reside on the same logical channel (LC), on different LCs in the same router, or on different
routers. One APS group must be configured for each protect port and its corresponding working ports.
Use the aps group (global) command to enter APS group configuration mode and configure APS connections
with other SONET equipment.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to use the aps group command in global configuration mode to configure
APS group 1 and enter APS group configuration mode:
RP/0/RSP0/CPU0:router(config)# aps group 1
RP/0/RSP0/CPU0:router(config-aps)#
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
842
SONET Controller Commands on the Cisco ASR 9000 Series Router
aps group (global)
To Next Page
Loading...
Need help?
General
