timeslots
To associate one or more DS0 time slots to a channel group and create an associated serial subinterface, use
the timeslots command in channel group configuration mode. To unassign the DS0 time slots and delete the
associated serial interface, use the no form of this command.
timeslots range
no timeslots
Syntax Description
range
Command Default
No default behavior or values
Command Modes
Channel group configuration for T1 and E1
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The time slot range must match the DS0 time slots assigned to the channel group. The service provider defines
the DS0 time slots that compose a channel group.
Before the channel group configuration is valid, you must define the associated DS0 time slots using the
timeslots command.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to associate DS0 time slots 1, 6, 8, 9 and 10 to channel group 5:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1e1)# channel-group 5
RP/0/RSP0/CPU0:router(config-t1e1-channel_group)# timeslots 1:6:8-10
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1069
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
timeslots
To Next Page
Loading...
Need help?
General
