show iccp group
To display information for the ICCP parameters, use the show iccp command in EXEC mode.
show iccp group {group-id| location node-id}
Syntax Description
ICCP group ID.
group-id
Specifies the location.location
Node ID. The node-id argument is entered in the rack/slot/module
notation.
node-id
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readmpls-ldp
Examples
The following example shows the output of the show iccp group command:
RP/0/RSP0/CPU0:router#show iccp group
Redundancy Group 1
member ip:2.2.2.2 (router2), up (connected)
monitor: route-watch (up)
backbone interface Gi0/2/0/3: up
enabled applications: mLACP
isolation recovery delay timer: 180 s, not running
Redundancy Group 2
member ip:2.2.2.2 (router2), up (disconnected)
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
643
Link Bundling Commands on the Cisco ASR 9000 Series Router
show iccp group
To Next Page
Loading...
Need help?
General
