show lacp packet-capture
To display the contents of Link Aggregation Control Protocol (LACP) packets that are sent and received on
an interface, use the show lacp packet-capture command in EXEC mode.
show lacp packet-capture [decoded] [in| out] {GigabitEthernet| TenGigE} interface-path-id
Syntax Description
(Optional) Displays packet information in decoded form for the specified interface.decoded
(Optional) Displays packet information for ingress packets only.in
(Optional) Displays packet information for egress packets only.out
Displays packet information for the Gigabit Ethernet interface specified by
interface-path-id.
GigabitEthernet
Displays packet information for the Ten Gigabit Ethernet interface specified by
interface-path-id.
TenGigE
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Command Default
The default displays both in and out information.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
653
Link Bundling Commands on the Cisco ASR 9000 Series Router
show lacp packet-capture
To Next Page
Loading...
Need help?
General
