Cisco A9K-SIP-700 Command Reference Guide

non-tcp compression
To enable non-TCP compression in an IP header compression (IPHC) profile, use the non-tcp compression
command in IPHC profile configuration mode. To disable non-TCP compression in the profile, use the no
form of this command.
non-tcp compression
no non-tcp
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
IPHC profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
NON-TCP compression can be enabled only within an IPHC profile. Non-TCP compression does not
work unless it is enabled under a profile.
Note
Task ID
OperationsTask ID
read, writeip-services
Examples
The following example shows how to enable NON-TCP compression within an IP header compression (IPHC)
profile:
RP/0/RSP0/CPU0:router(config)# config
RP/0/RSP0/CPU0:router(config)# iphc profile Profile_1 type iphc
RP/0/RSP0/CPU0:router(config-iphc-profile)# non-tcp compression
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
798
Serial Interface Commands on the Cisco ASR 9000 Series Router
non-tcp compression

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English