Cisco A9K-SIP-700 Command Reference Guide

report sd-ber
To enable Signal Degrade (SD) Bit Error Rate (BER) reporting, use the report sd-ber command in wanphy
configuration mode. To disable Signal Degrade (SD) Bit Error Rate (BER) reporting, use the no form of this
command.
report sd-ber
no report sd-ber
Syntax Description
This command has no keywords or arguments.
Command Default
Signal Degrade (SD) Bit Error Rate (BER) reporting is disabled by default.
Command Modes
Wanphy configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.0
Usage Guidelines
Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to enable Signal Degrade (SD) Bit Error Rate (BER) reporting.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# controller wanphy 0/6/1/0
RP/0/RSP0/CPU0:router(config-wanphy)# report sd-ber
RP/0/RSP0/CPU0:router(config-wanphy)#
Related Commands
DescriptionCommand
Disables SF BER reporting.report sf-ber disable, on page 1103
Displays alarms, registers, and module information for a
10-Gigabit Ethernet WAN PHY controller.
show controllers wanphy, on page 1105
Configures the threshold of the SF BER that is used to trigger
a link state change.
threshold sf-ber, on page 1116
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1102
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
report sd-ber

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English