interface (bundle)
To create a new bundle and enter interface configuration mode for that bundle, use the interface (bundle)
command in global configuration mode. To delete a bundle, use the no form of this command.
interface Bundle-Ether bundle-id
no interface Bundle-Ether bundle-id
Syntax Description
Specifies or creates an Ethernet bundle interface.Bundle-Ether
Number from 1 to 65535 that identifies a particular bundle.
bundle-id
Command Default
No bundle interface is configured.
Command Modes
Global configuration (config)
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
You must be in a user group associated with a task group that includes the proper task IDs. The command
reference guides include the task IDs required for each command. If you suspect user group assignment is
preventing you from using a command, contact your AAA administrator for assistance.
Task ID
OperationTask ID
read, writebundle
Examples
This example shows how to create an Ethernet bundle and enter interface configuration mode:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 3
RP/0/RSP0/CPU0:router(config-if)#
Related Commands
DescriptionCommand
Displays information about configured bundles.show bundle, on page 619
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
590
Link Bundling Commands on the Cisco ASR 9000 Series Router
interface (bundle)
To Next Page
Loading...
Need help?
General
