frame-relay lmi disable
To disable the Frame Relay Local Management Interface (LMI), use the frame-relay lmi disable command
in interface configuration mode. To reenable LMI, use the no form of this command.
frame-relay lmi disable
no frame-relay lmi disable
Syntax Description
This command has no keywords or arguments.
Command Default
LMI is enabled.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay lmi disable command is available on Packet-over-SONET/SDH (POS), serial, and multilink
interfaces.
Task ID
OperationsTask ID
read, writefr
Examples
The following example shows how to configure a DCE switch type on the interface:
RP/0/RSP0/CPU0:router(config)# interface pos 0/4/0/0
RP/0/RSP0/CPU0:router(config-if)# frame-relay lmi disable
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
433
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay lmi disable
To Next Page
Loading...
Need help?
General
