bundle load-balancing hash (EFP)
To configure all egressing traffic on a particular subinterface of a bundle to flow through the same physical
member link , use the bundle load-balancing hash (EFP) command in subinterface configuration mode.
bundle load-balancing hash hash-value [auto]
no bundle load-balancing hash hash-value [auto]
Syntax Description
Numeric value that specifies the physical member link through which all egressing
traffic in this bundle will flow. The values are 1 through 64.
hash-value
The physical member link through which all egressing traffic on this bundle will flow
is automatically chosen.
auto
Command Default
Ethernet flow point (EFP) load balancing is enabled.
Command Modes
Subinterface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
The hash-value range was changed from an upper limit of 8 to 64.
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command is only available on an Ethernet Bundle subinterface with Layer 2 transport (l2transport)
enabled.
This command allows the user to configure all egressing traffic on the fixed members of a bundle to flow
through the same physical member link. If the active members of the bundle change, the traffic for the bundle
may get mapped to a different physical link that has a hash value that matches the configured value.
Task ID
OperationsTask ID
read, writevlan
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
576
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle load-balancing hash (EFP)
To Next Page
Loading...
Need help?
General
