ModificationRelease
These keyword options were added:
•
one-way-delay-ds
•
one-way-delay-sd
•
one-way-jitter-ds
•
one-way-jitter-sd
Release 4.0.0
These keyword options were added:
•
one-way-loss-sd
one-way-loss-ds
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For statistics to be collected, at least one statistics entry must be present in each profile. To measure more
than one type of statistic, this command may be configured more than once in a single profile.
The one-way delay and jitter statistics are available for CFM delay measurement profile types only (profile
(SLA) command with the type cfm-delay-measurement keywords).
Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to enable the collection of round-trip-delay statistics, and enter the SLA profile
statistics configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet sla
RP/0/RSP0/CPU0:router(config-sla)# profile Prof1 type cfm-loopback
RP/0/RSP0/CPU0:router(config-sla-prof)# statistics measure round-trip-delay
RP/0/RSP0/CPU0:router(config-sla-prof-stat-cfg)#
Related Commands
DescriptionCommand
Enters the Ethernet SLA configuration mode.ethernet sla, on page 216
Creates an SLA operation profile and enter the SLA profile
configuration mode.
profile (SLA), on page 301
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
403
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
statistics measure
To Next Page
Loading...
Need help?
General
