ethernet oam
To enable Ethernet Link OAM, with default values, on an interface and enter interface Ethernet OAM
configuration mode, use the ethernet oam command in interface configuration mode. To disable Ethernet
Link OAM, use the no form of this command.
ethernet oam
no ethernet oam
Syntax Description
This command has no keywords or arguments.
Command Default
When enabled on an interface, the Ethernet Link OAM default values apply.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When you enable Ethernet Link OAM on an interface, the default Ethernet Link OAM values are applied to
the interface. For the default Ethernet Link OAM values, see the related Ethernet Link OAM commands.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to enable Ethernet Link OAM and enter interface Ethernet OAM
configuration mode.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/5/6
RP/0/RSP0/CPU0:router(config-if)# ethernet oam
RP/0/RSP0/CPU0:router(config-if-eoam)#
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
212
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet oam
To Next Page
Loading...
Need help?
General
