DescriptionField
Indicates that the hardware was configured as
controller loopback.
controller loopback
Number of LMI enquiry messages sent.LMI enq sent
Number of LMI status messages received.LMI stat recvd
Number of LMI updated messages received.LMI upd recvd
Number of LMI enquiry messages received.LMI enq recvd
Number of LMI status messages sent.LMI stat sent
Number of LMI updated messages sent.LMI upd sent
Displays the state of the DCE LMI.DCE LMI
Displays the LMI DLCI identifier.LMI DLCI
Displays the LMI type.LMI type
Time at which the counters that measure cumulative
statistics (such as number of bytes transmitted and
received) shown in this report were last reset to zero.
Note that variables that might affect routing for
example, load and reliability) are not cleared when
the counters are cleared.
Last clearing
Average number of bits and packets transmitted per
second in the last 5 minutes.
The 5-minute input and output rates should be used
only as an approximation of traffic per second during
a given 5-minute period. These rates are exponentially
weighted averages with a time constant of 5 minutes.
A period of four time constants must pass before the
average is within two percent of the instantaneous
rate of a uniform stream of traffic over that period.
5 minute input rate5 minute output rate
Total number of error-free packets received by the
system.
packets input
Total number of bytes, including data and MAC
encapsulation, in the error-free packets received by
the system.
bytes
Total number of broadcast or multicast packets
received by the interface
Received...broadcasts
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
489
Frame Relay Commands on the Cisco ASR 9000 Series Router
show interfaces (frame relay)
To Next Page
Loading...
Need help?
General
