Cisco A9K-SIP-700 Command Reference Guide

fragment end-to-end
To enable fragmentation of Frame Relay frames on an interface, use the fragment end-to-end command in
serial Frame Relay PVC configuration mode. To disable Frame Relay fragmentation, use the no form of this
command.
fragment end-to-end fragment-size
no fragment end-to-end
Syntax Description
Number of payload bytes from the original Frame Relay frame that go into each fragment.
This number excludes the Frame Relay header of the original frame.
All the fragments of a Frame Relay frame, except the last, have a payload size equal to
fragment-size; the last fragment has a payload less than or equal to fragment-size. Valid
values are from 64 to 512 bytes, depending on your hardware.
fragment-size
Command Default
Fragmentation is disabled by default.
Command Modes
Frame Relay virtual circuit configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
The Cisco 8-Port Channelized T1/E1 SPA supports fragment sizes of 128, 256, and 512 bytes.
Task ID
OperationsTask ID
read, writefr
Examples
The following example shows how to enter serial Frame Relay virtual circuit configuration mode, set the
fragmentation size of Frame Relay frames on subinterface 0/6/2/4.1 to 512 bytes:
RP/0/RSP0/CPU0:router(config)# interface serial 0/6/2/4.1 point-to-point
RP/0/RSP0/CPU0:router(config-subif)# pvc 100
RP/0/RSP0/CPU0:router(config-fr-vc)# fragment end-to-end 512
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
785
Serial Interface Commands on the Cisco ASR 9000 Series Router
fragment end-to-end

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English