Examples
This example shows how to configure the number of packets to be used to calculate FLR using the synthetic
loss calculation packets command:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet sla
RP/0/RSP0/CPU0:router(config-sla)# profile Prof1 type cfm-synthetic-loss-measurement
RP/0/RSP0/CPU0:router(config-sla-prof)# probe
RP/0/RSP0/CPU0:router(config-sla-prof-pb)# synthetic loss calculation packets 1250
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
410
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
synthetic loss calculation packets
To Next Page
Loading...
Need help?
General
