bundle
To create a multilink interface bundle, use the bundle command in the interface configuration mode. To
remove a multilink interface bundle, use the no form of this command.
bundle bundleID
Syntax Description
ID number of the multilink interface bundle. The bundle ID can be a 9-digit
number.
bundleID
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The bundle command is used in mgmtmultilink controller mode to dynamically create a multilink interface.
This command is similar to the channel-group command on the T1 controller, which dynamically creates a
serial interface.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to create a multilink interface with a bundle ID of 1:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# controller mgmtmultilink 0/1/0/0
RP/0/RSP0/CPU0:router(config-mgmtmultilink)# bundle 1
RP/0/RSP0/CPU0:router(config-mgmtmultilink)# commit
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
676
Multilink Commands on the Cisco ASR 9000 Series Router
bundle
To Next Page
Loading...
Need help?
General
