show lacp io
To display the Link Aggregation Control Protocol (LACP) transmission information that used by the
transmitting device for sending packets on an interface, use the show lacp io command in EXEC mode.
show lacp io {Bundle-Ether} bundle-id {GigabitEthernet| TenGigE} interface-path-id
Syntax Description
(Optional) Displays information for the Ethernet bundle interface with the
specified bundle-id. The range is 1 through 65535.
Bundle-Ether bundle-id
(Optional) Displays information for the Gigabit Ethernet interface with the
specified interface-path-id.
GigabitEthernet
(Optional) Displays information for the Ten Gigabit Ethernet interface with the
specified interface-path-id.
TenGigE
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Command Default
The default takes no parameters and displays information for all actively transmitting interfaces.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command displays information only for interfaces that are actively transmitting packets.
Task ID
OperationsTask ID
readbundle
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
650
Link Bundling Commands on the Cisco ASR 9000 Series Router
show lacp io
To Next Page
Loading...
Need help?
General
