Cisco A9K-SIP-700 Command Reference Guide

g709 otu overhead tti
To configure the OTU Trail Trace Identifier (TTI) buffer for a DWDM controller, use the g709 otu overhead
tti command in DWDM configuration mode. To return to the default state, use the no form of this command.
g709 otu overhead tti {expected| sent} {ascii| hex} tti-string
no g709 otu overhead tti {expected| sent} {ascii| hex} tti-string
Syntax Description
Configures the expected TTI string.expected
Configures the transmit TTI string.sent
Indicates that the string is in ASCII format.ascii
Indicates that the string is in hexidecimal format.hex
The TTI string. A maximum of 64 characters is allowed.tti-string
Command Default
No TTI string is configured
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To display the TTI strings, use the show controller dwdm g709 command.
Task ID
OperationsTask ID
read, writedwdm
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
15
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
g709 otu overhead tti

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English