action high-threshold
To configure what action is taken on an interface when a high threshold is exceeded, use the action
high-threshold command in Ethernet OAM configuration mode or interface Ethernet OAM configuration
mode. To return to the default, use the no form of this command.
action high-threshold {disable| error-disable-interface| log}
no action high-threshold {disable| error-disable-interface| log}
Syntax Description
(Interface Ethernet OAM configuration only) Performs no action on the interface
when a high threshold is exceeded.
disable
Puts the interface into the error-disable state when a high threshold is exceeded.error-disable-interface
Creates a syslog entry when a high threshold is exceeded. This action is available
only in interface Ethernet OAM configuration mode to override the OAM profile
on a specific interface.
log
Command Default
The default is that no action is taken when a high threshold is exceeded.
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
143
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
action high-threshold
To Next Page
Loading...
Need help?
General
