frame-relay lmi-n392dte
To set the error threshold on a DTE interface, use the frame-relay lmi-n392dte command in interface
configuration mode. To restore the default setting, use the no form of this command.
frame-relay lmi-n392dte threshold
no frame-relay lmi-n392dte threshold
Syntax Description
Error threshold value. Range is from 1 to 10. The default is 3.
threshold
Command Default
The DTE error threshold is 3.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay lmi-n392dte command is relevant only when the interface type is data terminal equipment
(DTE).
This command is available on Packet-over-SONET/SDH (POS), serial, and multilink interfaces.
Task ID
OperationsTask ID
read, writefr
Examples
The following example shows how to set the Local Management Interface (LMI) failure threshold to 4. The
router acts as a Frame Relay DTE switch.
RP/0/RSP0/CPU0:router(config)# interface pos 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# frame-relay intf-type dte
RP/0/RSP0/CPU0:router(config-if)# frame-relay lmi-n392dte 4
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
438
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay lmi-n392dte
To Next Page
Loading...
Need help?
General
