Ten GigE interfaces will not show egress statistics when loopback line is configured because the loopback
is closed at the interface controller level, before the Network Processor (NP). But on One GigE interfaces
the line loopback is closed in the NP.
Note
Task ID
OperationTask ID
read, writeinterface
Examples
This example shows how to enter interface configuration mode for a Ten Gigabit Ethernet interface:
RP/0/RSP0/CPU0:router(config)# interface TenGigE 0/4/0/0
RP/0/RSP0/CPU0:router(config-if)#
Related Commands
DescriptionCommand
Displays statistics for all interfaces configured on the router or for
a specific node.
show interfaces, on page 516
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
86
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
interface (Ethernet)
To Next Page
Loading...
Need help?
General
