frame-relay multilink hello
To configure the hello interval used by a Frame Relay multilink bundle link, use the frame-relay multilink
hello command in interface configuration mode. To reset the name to the default, use the no form of this
command.
frame-relay multilink hello hello-interval
no frame-relay multilink hello
Syntax Description
Hello interval for the Frame Relay multilink bundle link, in seconds. The
range is from 1 to 180.
hello-interval
Command Default
The default hello interval is 10 seconds.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay multilink hello command is supported only on serial interfaces. The frame-relay
multilink hello command is not supported on Packet-over-SONET/SDH (POS) or multilink frame relay
interfaces.
Note
The frame-relay multilink hello command can be configured only on bundle link interfaces that have been
associated with a bundle using the encapsulation frame-relay mfr command.
You can enter the frame-relay multilink hello command at any time without affecting the current state
of the interface; however, the configured hello interval value does not go into effect until the interface has
gone from the down state to the up state. One way to bring the interface down and back up again is by
using the shutdown and no shutdown commands in interface configuration mode.
Note
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
454
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay multilink hello
To Next Page
Loading...
Need help?
General
