threshold sf-ber
To configure the threshold of the Signal Failure (SF) Bit Error Rate (BER) that is used to trigger a link state
change, use the threshold sf-ber command in wanphy configuration mode. To return the Signal Failure (SF)
Bit Error Rate (BER) to the default value, use the no form of this command.
threshold sf-ber exponenet
no threshold sf-ber exponenet
Syntax Description
Value of 10 raised to the n power, where n is the exponent of 10, as in10-n. Valid
values are 3 to 9, meaning 10-3 to 10-9.
exponent
Command Default
The default is 3, meaning (10-3).
Command Modes
Wanphy configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.0
Usage Guidelines
Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to configure the threshold of the Signal Failure (SF) Bit Error Rate (BER):
RP/0/RSP0/CPU0:router # configure
RP/0/RSP0/CPU0:router(config)# controller wanphy 0/6/1/0
RP/0/RSP0/CPU0:router(config-wanphy)# threshold sf-ber 9
RP/0/RSP0/CPU0:router(config-wanphy)#
Related Commands
DescriptionCommand
Enables Signal Degrade (SD) Bit Error Rate (BER) reporting.report sd-ber, on page 1102
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1116
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
threshold sf-ber
To Next Page
Loading...
Need help?
General
