bundle-hash
To display the source and destination IP addresses for the member links, distributed by the load balancing
feature, in a multilink interface bundle, use the bundle-hash command in EXEC mode.
bundle-hash {Bundle-Ether bundle-id| members {GigabitEthernet| TenGigabitEthernet} interface-path-id}
Syntax Description
Specifies an Ethernet bundle for which you want to calculate load balancing.
Range is 1- 65535.
Bundle-Ether bundle-id
Identifies specific bundle member links for which you want to calculate load
balancing.
members
Specifies the Gigabit Ethernet interface for which you want to calculate load
balancing.
GigabitEthernet
Specifies the 10 Gigabit Ethernet interface for which you want to calculate
load balancing.
TenGigE
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Command Default
No default behavior or values
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Bundle interface traffic is distributed over the various member links of a bundle according to a hash function.
The bundle-hash command allows you to determine which bundle member link will carry a particular flow
of traffic.
You can use the bundle-hash command to get these information:
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
567
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle-hash
To Next Page
Loading...
Need help?
General
