frame-relay lmi-n393dce
To set the DCE monitored events count, use the frame-relay lmi-n393dce command in interface configuration
mode. To restore the default setting, use the no form of this command.
frame-relay lmi-n393dce events
no frame-relay lmi-n393dce events
Syntax Description
Monitored events count. Range is from 1 to 10. The default is 4.
events
Command Default
The number of DCE monitored events is 4.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay lmi-n393dce command is used along with the frame-relay lmi-n392dce command to define
the condition that causes the link to be declared down.
N392 errors must occur within the events argument count in order for the link to be declared down. Therefore,
the events value defined in this command must be greater than the threshold value defined in the frame-relay
lmi-n392 dce command.
The frame-relay lmi-n393dce command is relevant only when the interface type is data communication
equipment (DCE).
This frame-relay lmi-n393dce command is available on Packet-over-SONET/SDH (POS), serial, and multilink
interfaces.
Task ID
OperationsTask ID
read, writefr
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
439
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay lmi-n393dce
To Next Page
Loading...
Need help?
General
