hello-interval
To specify the time interval between hello packets for an Ethernet OAM session, use the hello-interval
command in Ethernet OAM or interface Ethernet OAM configuration mode. To return to the default, use the
no form of the command.
hello-interval {100ms| 1s}
no hello-interval {100ms| 1s}
Syntax Description
Specifies a 100-millisecond interval between hello packets.100ms
(Interface Ethernet OAM configuration mode only) Specifies a 1-second interval
between hello packets. This is the default.
1s
Command Default
The default is 1 second.
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If a profile exists on the interface, setting the mode with this command overrides the mode setting in the profile
on an interface.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to set the hello interval to 100 milliseconds on a Gigabit Ethernet interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/5/6
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
260
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
hello-interval
To Next Page
Loading...
Need help?
General
