Specifies the number of packets to be sent in a
burst, in the range 2 to 600. The default is 10.
packet count number
Specifies the time between sending packets in a
burst, where number is in the following range:
•
100 to 30000 milliseconds
•
1 to 30 seconds
The total length of a burst (the packet
count multiplied by the interval) must not
exceed 1 minute.
Note
interval number {milliseconds | seconds}
Minimum size of the packet including padding
when necessary. The range is 1 to 9000 bytes. This
value is the total frame size including the Layer 2
or Layer 3 packet header.
packet sizebytes
(Optional) Specifies a 4-byte string (8 hexadecimal
characters) to repeat as many times as required to
fill the outgoing probe packet to the specified
minimum packet size. The default is all 0s.
test pattern hex 0x HHHHHHHH
Defines the number of packets that must be used
to make each FLR calculation for synthetic loss
measurements. It ranges from 10 to 12096000.
synthetic loss calculation packetsnumber
Specifies the name of the domain for the locally
defined CFM MEP.
domain domain-name
Specifies the source interface type of the locally
defined CFM MEP. For more information, use the
question mark (?) online help function.
source interface type
Physical interface or virtual interface.
Use the show interfaces command to see
a list of all interfaces currently configured
on the router.
Note
For more information about the syntax for the
router, use the question mark (?) online help
function.
interface-path-id
Specifies the MAC address (in dotted hexadecimal
format) of the target MEP that is known to the local
MEP for the probe.
target mac-address H.H.H
Specifies the ID (from 1 to 8191) of the target MEP
that is known to the local MEP for the probe.
target mep-id id-number
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
240
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-synthetic-loss-measurement probe
To Next Page
Loading...
Need help?
General
