Command Default
Default interval period is 300 seconds.
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 5.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When error disable recovery is enabled, the interface automatically recovers from the error-disabled state,
and the device retries bringing the interface up.
Task ID
OperationTask ID
read, writeethernet-services
Examples
This example shows how to enable error disable recovery for cluster-udld with interval 60:
RP/0/RSP0/CPU0:router#configure
RP/0/RSP0/CPU0:router#error-disable recovery cause cluster-udld interval 60
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
206
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
error-disable recovery cause
To Next Page
Loading...
Need help?
General
