Cisco A9K-SIP-700 Command Reference Guide

lldp (interface)
To enter LLDP configuration mode, use the lldp (interface) command.
lldp
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeethernet-services
read, writeinterface
Examples
This example shows how to enter LLDP configuration mode from Ethernet interface configuration mode:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/1/0/0
RP/0/RSP0/CPU0:router(config-if)# lldp
RP/0/RSP0/CPU0:router(config-lldp)#
Related Commands
DescriptionCommand
Specifies or creates an Ethernet interface and enters interface
configuration mode.
interface (Ethernet), on page 85
Enables LLDP globally for both transmit and receive operation on
the system.
lldp, on page 87
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
89
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
lldp (interface)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English