bundle id
To add a port to an aggregated interface (or bundle), enter the bundle id command in interface configuration
mode.
bundle id bundle-id [mode {active| on| passive}]
no bundle id bundle-id
Syntax Description
Number of the bundle (from 1 to 65535) on which you want to add a port.
bundle-id
(Optional) Specifies the mode of operation, as follows:
• active—Use the mode active keywords to run Link Aggregation Control Protocol
(LACP) in active mode over the port. When you specify active, the port joins the bundle
and is activated if LACP determines that it is compatible.
• on—Use the mode on keywords to configure an Etherchannel link over the port (no
LACP running over the port).
• passive—Use the mode passive keywords to run LACP in passive mode over the port.
When you specify passive, LACP packets are sent only if the other end of the link is
using active LACP. The link joins the bundle and is activated if LACP packets are
exchanged and the port is compatible.
mode
Command Default
The default setting is mode on.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If you enter the bundle id command and specify a port that is already bound to a bundle, the port unbinds
from the original bundle and becomes attached to the new bundle. If the bundle numbers are the same, then
the port does not unbind, but the mode changes to mode you specified with the bundle id command.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
572
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle id
To Next Page
Loading...
Need help?
General
