Cisco A9K-SIP-700 Command Reference Guide

controller MgmtMultilink
To configure a controller for a generic multilink bundle and enter MgmtMultilink configuration mode, use
the controller MgmtMultilink command in global configuration mode. To return to the default state, use
the no form of this command.
controller MgmtMultilink interface-path-id
no controller MgmtMultilink interface-path-id
Syntax Description
Virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the interface-path-id argument, use the following guidelines:
•
If specifying a physical interface, the naming notation is rack/slot/module/instance. The slash between
values is required as part of the notation. An explanation of each component of the naming notation is
as follows:
◦
rack: Chassis number of the rack.
◦
slot: Physical slot number of the line card.
◦
module: Module number.
◦
instance: Number of the controller instance. The instance is always 0.
•
If specifying a virtual interface, the number range varies, depending on interface type.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
678
Multilink Commands on the Cisco ASR 9000 Series Router
controller MgmtMultilink

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English