negotiation auto
To enable link autonegotiation on Gigabit Ethernet interfaces, use the negotiation auto command in interface
configuration mode. To disable link autonegotiation, use the no form of this command.
negotiation auto
no negotiation auto
Syntax Description
This command has no keywords or arguments.
Command Default
Link autonegotiation is disabled.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was first introduced.Release 3.7.2
The negotiation auto command was supported on 1 Gigabit Ethernet
interfaces.
Release 4.2.3
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The negotiation auto command is available on Gigabit Ethernet interfaces only.
Task ID
OperationsTask ID
read, writeinterface
Examples
This example shows how to enable link autonegotiation on an interface:
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/0/2/0
RP/0/RSP0/CPU0:router(config-if)# negotiation auto
This example shows how to disable link autonegotiation on an interface:
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/0/2/0
RP/0/RSP0/CPU0:router(config-if)# no negotiation auto
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
103
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
negotiation auto
To Next Page
Loading...
Need help?
General
