clear counters wanphy
To clear the alarms counters for a specific 10-Gigabit Ethernet WAN PHY interface, use the clear counters
wanphy command in EXEC mode.
clear counters wanphy interface-id stats
Syntax Description
Physical interface instance. Naming notation is rack/slot/module/port and a slash between
values is required as part of the notation.
•
rack: Chassis number of the rack.
•
slot: Physical slot number of the line card.
•
module: Module number. A physical layer interface module (PLIM) is always 0.
Shared port adapters (SPAs) are referenced by their subslot number.
•
port: Physical port number of the interface.
For more information about the syntax for the router, use the question mark (?) online help
function.
interface-id
Clears alarm counters for the specified 10-Gigabit Ethernet WAN interface.stats
Command Default
No default behavior or values
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, write, executeinterface
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1098
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
clear counters wanphy
To Next Page
Loading...
Need help?
General
