profile (EOAM)
To attach an Ethernet OAM profile to an interface, use the profile command in interface Ethernet OAM
configuration mode. To remove the profile from the interface, use the no form of this command.
profile name
no profile name
Syntax Description
Text name of the Ethernet OAM profile to attach to the interface.
name
Command Default
No profile is attached.
Command Modes
Interface Ethernet OAM configuration (config-if-eoam)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When an Ethernet OAM profile is attached to an interface using this command, all of the parameters configured
for the profile are applied to the interface.
Individual parameters that are set by the profile configuration can be overridden by configuring them directly
on the interface.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to attach an Ethernet OAM profile to a Gigabit Ethernet interface.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/5/6
RP/0/RSP0/CPU0:router(config-if)# ethernet oam
RP/0/RSP0/CPU0:router(config-if-eoam)# profile Profile_1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
299
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
profile (EOAM)
To Next Page
Loading...
Need help?
General
