show iphc ipv4 tcp
To display IPv4 Transport Control Protocol (TCP) statistics about IP header compression (IPHC) packets
sent and received on an interface, use the show iphc ipv4 tcp command in EXEC mode.
show iphc ipv4 tcp interface type interface-path-id [ location node-id ]
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Specifies the location of the interfacelocation
(Optional) Node-id entered in the rack/slot/module notation.node-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
These Cisco support commands are normally reserved for use by Cisco Technical Support personnel only.
If used incorrectly. there is some risk that they may cause performance or other issues that impact products,
and we highly recommend that you contact Cisco Technical Support before using any of these commands.
Caution
Task ID
OperationsTask ID
readip-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
814
Serial Interface Commands on the Cisco ASR 9000 Series Router
show iphc ipv4 tcp
To Next Page
Loading...
Need help?
General
