description (IPHC profile)
To add a description to an IPHC profile, use the description command in IPHC profile configuration mode.
To remove a description for an IPHC profile, use the no form of this command.
description description
no description
Syntax Description
Description to be added to the IPHC profile.
description
Command Default
By default, no description is attached to an IPHC profile.
Command Modes
IPHC profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeip-services
Examples
In the following example, a description is attached to the IPHC profile test:
RP/0/RSP0/CPU0:router(config)# config
RP/0/RSP0/CPU0:router(config)# iphc profile test type iphc
RP/0/RSP0/CPU0:router(config-iphc-profile)# description testprofile
RP/0/RSP0/CPU0:router(config-iphc-profile)# commit
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
781
Serial Interface Commands on the Cisco ASR 9000 Series Router
description (IPHC profile)
To Next Page
Loading...
Need help?
General
