multilink
To enter the config-if-multilink submode, use the multilink command in the interface configuration mode.
multilink
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For multilink interfaces, the multilink command provides access to the config-if-multilink submode to use
the multilink fragment-size command.
Task ID
OperationsTask ID
read, writehdlc
Examples
The following example shows how to enter the config-if-multilink submode:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1/1/1:0
RP/0/RSP0/CPU0:router(config-if)# multilink
RP/0/RSP0/CPU0:router(config-if-multilink)# group 1
RP/0/RSP0/CPU0:router(config-if-multilink)# commit
Related Commands
DescriptionCommand
Attaches a serial interface to a multilink interface bundle.multilink group, on page 685
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
682
Multilink Commands on the Cisco ASR 9000 Series Router
multilink
To Next Page
Loading...
Need help?
General
