non-tcp context absolute
To configure the maximum number of non-TCP contexts that are allowed for IPHC under a profile, use the
non-tcp context absolute command in IPHC profile configuration mode. To remove the non-TCP context
from the profile, use the no form of this command.
non-tcp context absolute number-of-contexts
no non-tcp context [absolute [ number-of-contexts ]]
Syntax Description
Numeric value that specifies the maximum number of non-TCP contexts
allowed for IPHC under this profile. The range is from 0 to 6000.
number-of-contexts
Command Default
If the number of contexts is not specified, and only non-TCP compression is enabled, the default number of
contexts is 16.
Command Modes
IPHC profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The maximum allowed number of non-tcp contexts on a Line Card, across all IPHC profiles and interfaces,
is 6000.
Non-TCP context can be set only within an IPHC profile.Note
Task ID
OperationsTask ID
read, writeip-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
799
Serial Interface Commands on the Cisco ASR 9000 Series Router
non-tcp context absolute
To Next Page
Loading...
Need help?
General
