ethernet udld reset interface
To reset the UDLD protocol state for a specified interface or for all interfaces, use the ethernet udld reset
interface command in the Ethernet Interface Configuration mode.
ethernet udld reset interface [interface type |all ]
Syntax Description
(Optional) Specifies the interface type for which the UDLD protocol state
needs to be reset.
interface type
(Optional) Resets the UDLD state for all interfaces.all
Command Default
No default behavior or values
Command Modes
Ethernet Interface Configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
readethernet-services
Examples
This example shows how to run the ethernet udld reset interface command:
RP/0/RSP0/CPU0:router# ethernet udld reset interface GigabitEthernet 0/10/0/11
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
244
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet udld reset interface
To Next Page
Loading...
Need help?
General
