connection timeout
To configure the timeout value for an Ethernet OAM session, use the connection timeout command in Ethernet
OAM configuration mode.
connection timeout seconds
Syntax Description
Connection timeout period in number of lost periodic information OAMPDUs.
The range is 2 to 30.
seconds
Command Default
The default value is 5.
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If no packets are received from the OAM peer in the specified connection timeout period which is measured
in number of lost periodic Information OAMPDUs, then the OAM session is brought down, and the negotiation
phase starts again.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to configure the connection timeout value of an Ethernet OAM session:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# connection timeout 20
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
188
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
connection timeout
To Next Page
Loading...
Need help?
General
