debug ethernet cfm protocol-state
To log debug messages about CFM state machines and protocol events, use the debug ethernet cfm
protocol-state command in EXEC mode.
debug ethernet cfm protocol-state [domain domain-name [service service-name [mep-id mep-id]]] [interface
type interface-path-id [domain domain-name]]
Syntax Description
(Optional) Filters information for display by the specified CFM maintenance
domain, where domain-name is a string of up to 80 characters.
domain domain-name
(Optional) Filters information for display by the specified service name, where
service-name is a string of up to 80 characters.
service service-name
(Optional) Filters information for display by the specified maintenance end
point (MEP) ID number. The range for MEP ID numbers is 1 to 8191.
mep-id mep-id
(Optional) Filters information for display by the specified physical interface or
virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface type
interface-path-id
Command Default
If no parameters are specified, all CFM state machines and protocol events are debugged and logged.
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Debug messages can be filtered by specifying any of the optional parameters.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
199
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
debug ethernet cfm protocol-state
To Next Page
Loading...
Need help?
General
