frame-relay multilink ack
To configure the MFR acknowledge timeout value for a Frame Relay multilink bundle link, use the frame-relay
multilink ack command in interface configuration mode. To revert to the default settings, use the no form
of this command.
frame-relay multilink ack ack-timeout
no frame-relay multilink ack
Syntax Description
Ack timeout value, in seconds. The range is from 1 to 10.
ack-timeout
Command Default
The default MFR acknowledge timeout value is 4 seconds.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay multilink ack command is supported only on serial interfaces. The frame-relay multilink
ack command is not supported on Packet-over-SONET/SDH (POS) or multilink frame relay interfaces.
Note
The frame-relay multilink ack command can be configured only on bundle link interfaces that have been
associated with a bundle using the encapsulation frame-relay mfr command.
You can enter the frame-relay multilink ack command at any time without affecting the current state of
the interface; however, the configured timeout value does not go into effect until the interface has gone
from the down state to the up state. One way to bring the interface down and back up again is by using
the shutdown and no shutdown commands in interface configuration mode.
Note
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
448
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay multilink ack
To Next Page
Loading...
Need help?
General
