monitoring
To enable Ethernet OAM link monitoring, use the monitoring command in Ethernet OAM link monitor or
interface Ethernet OAM link monitor configuration mode. To return link monitoring to its default state of
enabled, use the no form of this command.
monitoring [disable]
no monitoring [disable]
Syntax Description
(Optional) Disables Ethernet OAM link monitoring.
When configuring on a profile, only the monitoring disable form of the
command is supported.
Note
disable
Command Default
Link monitoring is enabled by default.
Command Modes
Ethernet OAM link monitor configuration (config-eoam-lm)
Interface Ethernet OAM link monitor configuration (config-if-eoam-lm)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Monitoring is enabled by default. To disable it either on a profile or an interface, use the monitoring disable
form of the command.
If monitoring is disabled on a profile, but you want to override the configuration and enable it for an interface,
use the monitoring command in interface Ethernet OAM link monitor configuration mode.
You cannot configure the monitoring command without the disable keyword on a profile.
Task ID
OperationsTask ID
read, writeethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
287
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
monitoring
To Next Page
Loading...
Need help?
General
