Information You Need to ProvideOption
L3 information:
•
Source IP address
•
Destination IP address
•
Protocol
L4 information:
•
Source port
•
Destination port
Platform-related information:
•
Router ID
•
Ingress interface
L4/7-tuple
Information for a single source port and destination
port. The utility uses this information to calculate the
hash and display the bundle load-balance distribution
among the user-provided physical/bundle links.
The default is single mode.
While in single mode, you may receive the following
prompt:
Single pair
Information for sets of source and destination
addresses to generate a packet flow for each set. The
utility uses this information to calculate the hash for
the generated packet flows and display the
user-provided egress member links/bundle interfaces
and the number of packet flows on each link.
Range
IPv4 addressesIPv4
IPv6 addressesIPv6
Compute destination address set for all members [y|n]:
If you enter y(es), several sample IPv4 addresses in the destination subnet are generated, and the link is
calculated for each sample address. During this calculation, the destination network address is derived from
the destination IPv4 address and the subnet prefix.
Task ID
OperationsTask ID
readbundle
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
569
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle-hash
To Next Page
Loading...
Need help?
General
