frame-relay intf-type
To configure the interface type of the User-Network Interface (UNI), use the frame-relay intf-type command
in interface configuration mode. To change the configuration, use the no form of this command.
frame-relay intf-type {dce| dte| nni}
no frame-relay intf-type {dce| dte| nni}
Syntax Description
Router functions as a switch connected to a router.dce
Router is connected to a Frame Relay network.dte
Router is connected to a NNI signaling interface.nni
Command Default
DTE
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
The nni keyword was introduced.Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay intf-type command is available on Packet-over-SONET/SDH (POS), serial, and multilink
interfaces.
Task ID
OperationsTask ID
read, writefr
Examples
The following example shows how to configure a DCE switch type on the interface:
RP/0/RSP0/CPU0:router(config)# interface pos 0/4/0/0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
431
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay intf-type
To Next Page
Loading...
Need help?
General
