g709 tti-processing
To enable Trace Identifier Mismatch (TIM) alarms, use the g709 tti-processing command in DWDM
configuration mode. To disable TIM alarms, use the no form of this command.
g709 tti-processing
no g709 tti-processing
Syntax Description
This command has no keywords or arguments.
Command Default
By default, trace identifier mismatch (TIM) alarms are disabled.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Trace identifier mismatch (TIM) alarms can be set only when TTI processing is enabled.Note
Task ID
OperationsTask ID
read, writedwdm
Examples
This example shows how to configure the expected TTI string:
RP/0/RSP0/CPU0:router(config)# controller dwdm 0/1/0/0
RP/0/RSP0/CPU0:router(config-dwdm)# g709 tti-processing
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
22
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
g709 tti-processing
To Next Page
Loading...
Need help?
General
