pm otn report enable
To enable Threshold Crossing Alert (TCA) generation on the Optical Transport Network (OTN) layer, use
the pm otn report enable command in DWDM configuration mode. To disable TCA reporting, use the no
form of this command.
pm {15-min| 24-hour} otn report otn-parameter enable
no pm {15-min| 24-hour} otn report otn-parameter enable
Syntax Description
Configures TCA generation for 15-minute intervals.15-min
Configures TCA generation for 24-hour intervals.24-hour
Specific parameter for which to configure the threshold. OTN parameters can be as follows:
• bbe-pm-fe—Far-end path monitoring background block errors (BBE-PM). Indicates
the number of background block errors recorded in the optical transport network (OTN)
path during the performance monitoring time interval.
• bbe-pm-ne—Near-end path monitoring background block errors (BBE-PM).
• bbe-sm-fe—Far-end section monitoring background block errors (BBE-SM). Indicates
the number of background block errors recorded in the OTN section during the
performance monitoring time interval.
• bbe-sm-ne—Near-end section monitoring background block errors (BBE-SM).
• bber-pm-fe—Far-end path monitoring background block errors ratio (BBER-PM).
Indicates the background block errors ratio recorded in the OTN path during the
performance monitoring time interval.
• bber-pm-ne—Near-end path monitoring background block errors ratio (BBER-PM).
• bber-sm-fe—Far-end section monitoring background block errors ratio (BBER-SM).
Indicates the background block errors ratio recorded in the OTN section during the
performance monitoring time interval.
• bber-sm-ne—Near-end section monitoring background block errors ratio (BBER-SM)
• es-pm-fe—Far-end path monitoring errored seconds (ES-PM). Indicates the errored
seconds recorded in the OTN path during the performance monitoring time interval.
• es-pm-ne—Near-end path monitoring errored seconds (ES-PM).
• es-sm-fe—Far-end section monitoring errored seconds (ES-SM). Indicates the errored
seconds recorded in the OTN section during the performance monitoring time interval.
• es-sm-ne—Near-end section monitoring errored seconds (ES-SM).
• esr-pm-fe—Far-end path monitoring errored seconds ratio (ESR-PM). Indicates the
errored seconds ratio recorded in the OTN path during the performance monitoring time
interval.
otn-parameter
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
40
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
pm otn report enable
To Next Page
Loading...
Need help?
General
