Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to configure the time interval at which continuity-check messages are transmitted
and set the threshold limit for when a MEP is declared down.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet cfm
RP/0/RSP0/CPU0:router(config-cfm)# domain Domain_One level 1 id string D1
RP/0/RSP0/CPU0:router(config-cfm-dmn)# service Bridge_Service bridge group BD1 bridge-domain
B1
RP/0/RSP0/CPU0:router(config-cfm-dmn-svc)# continuity-check interval 100ms loss-threshold
10
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
192
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
continuity-check interval
To Next Page
Loading...
Need help?
General
