serial
To configure the serial parameters and enter serial configuration mode, use the serial command in interface
configuration mode. To return to the default state of the serial interface, use the no form of this command.
serial
no serial
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Serial interfaces are automatically created for unchannelized ports; for channelized ports, serial interfaces are
created when you add T1/E1 channel groups.
Task ID
OperationsTask ID
read, writehdlc
Examples
The following example shows how to enter serial configuration mode:
RP/0/RSP0/CPU0:router(config-if)# serial
RP/0/RSP0/CPU0:router(config-if-serial)#
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
809
Serial Interface Commands on the Cisco ASR 9000 Series Router
serial
To Next Page
Loading...
Need help?
General
